# ausführliche Variante von EDIABAS.ini (mit Kurz-Info und Default) #

CodeMapping = C:\EC-Apps\EDIABAS\BIN\ansi2oem.tab I have also bridged the 7/8 pin on the cableĭevice Manage: Ports USB Serial Port: COM7 / Latency 1 I tried a full re-install and followed all of the steps, but am assuming I still have something not quite right in my EDIABAS.ini file. I have a K+DCAN USB Interface (INPA Compatible), but can't seem to get the ignition showing to on and get the below error. I have spent a few days looking over the forums and trying all different settings to get my INPA connecting, so I can reset the steering angle sensor. IFH009 - needed to flick the switch on the cable (pre/post 2006)

OBD.ini File - Confirm Port matches above COM1, updated Hardware=USB Latency - Confirmed it had been set to 1 in Device Manager In summary, I got the following 3 issues come up.after resolving one, I got the next:ĬOM Port - Made COM1 the port in Device Manager and confirmed it was the same in the OBD file.